|
|
|
|
Video will loop continuously |
|
|
|
|
|
Equipment |
Typical ASB Control Settings |
|
(1) SEECO two-way switch |
SW1 - Open at 10 seconds (loss of potential) AND |
|
(2) SEECO motor operators |
SW2 - Open at 10 seconds (loss of potential) |
|
(2) SEECO voltage sensors, type VS |
|
|
(1) SEECO local control logic device, type ASB |
SW1 - Close at 5 seconds (gain of potential) OR |
|
|
SW2 - Close at 5 seconds (gain of potential) ELSE |
|
Typical Breaker Timing |
|
|
20 cycles |
SW1 and SW2 - Lockout if both Sensor 1 and 2 regain |
|
15 seconds |
potential |
|
60 seconds |
|
|
|
|
Note: the above breaker timing
and ASB control settings are for illustration purposes only; your application may have
values that are specific to your automation objectives and current
equipment settings |
|
|
