Short video clips of key
adjustments for many of our most popular products can be viewed here.
Please note that these video clips are to be used in conjunction with the
erection drawings and printed installation instructions supplied with your
specific order and are not intended to be a substitute
or short cut for complete and thorough review of the supplied documentation.
To view a video, click on the
hyperlink for the desired adjustment procedure and you will be
automatically re-directed to YouTube® where the video
will load and display. When you have finished viewing the video,
remember to use the 'back' button to return to this page where you can
then select another video for presentation.
If you have additional questions
after reading the installation instructions and viewing the video, we
encourage you to contact the Factory and
speak with an Application Engineer. We welcome the opportunity to
assist you.
Group
Operated Switch Adjustments
Getting started - recommended
tools, preparation for work activities, where to go for help or assistance
GOS-01 Rocker Bottom
Adjustment - provides
adjustment of the blade end, which should be centered vertically relative
to the rear two fingers of the jaw
GOS-02 Blade
Insertion Depth - provides
adjustment for the proper depth of the blade into the jaw and
the correct alignment of the jaw and jaw housing to the blade
Rotating insulator stop - adjust
stop position to prevent over-travel of the blade when opening and closing
Piercing set screws - our
recommended method to avoid stripping threads
POP-01 Interphase Pipe Toggle Adjustment - describes the adjustment procedure for toggle of the interphase pipe and crank arm; toggle mechanically precludes the accidental or unintended
opening of the switch
Rotating insulator bearing -
proper orientation of 5" bolt circle bearing
Insulator alignment or leveling -
typically not required
Arcing Horn Adjustments
Arcing Horn and Hook
HVW and Hook
Multi-Bottle Vacuum Interrupter Adjustments
Getting started - recommended
tools, preparation for work activities, where to go for help or assistance
MBI-01 Blade Clamp Adjustment -
positions the blade clamp at the proper distance from the end of the blade for proper engagement of
the interrupter trip arm during switch opening
MBI-02 Auxiliary Contact
Adjustment -
positions the auxiliary stationary contact for proper engagement of the
moving contact during switch closing
MBI-03 Pick-Up Rod Adjustment -
provides adjustment of the pick-up rod for proper engagement of the
interrupter trip arm in opening
Motor Operator Adjustments
Getting started - recommended
tools, preparation for work activities, where to go for help or assistance
|