What's New
|
|
|
|
|
|
|
 |
SEECO is now manufacturing 230 kV
phase-over-phase one-way,
two-way, three-way and
in-line switches, in both air-break and full
load-break configurations. Amperage ratings include 600, 1200, 2000 and
3000 amps. Contact the factory or your local sales representative for additional details. |
| |
|
%20copy.jpg) |
Amperage ratings for phase-over-phase GOABS®
switches and Monoruptr® vacuum interrupter
have now been increased to 3000 amps, including all
one-way, two-way,
three-way and in-line switch configurations
and all voltages. Contact the factory or your local sales
representative for additional details. |
| |
|
 |
SEECO has expanded our vacuum interrupter product line and we now offer
retro-fit kits for other brands of group operated switches, including Pascor Atlantic, USCO and Royal. Retro-fit kits are
available in both single and multi bottle interrupter configurations for
center Vee, vertical break and side break switches. Retro-fit kits for
other brands are currently under development. |
| |
|
 |
The High Velocity Whip (HVW)
is a spring loaded, stored energy arcing horn providing substantially greater
interruption of line charging currents than traditional or other enhanced horn
designs. Designed to open a very large air gap within the first cycle
after separation, the whip also employs a Delrin®
tip, which assists in the dissipation of ionized gases.
Recently tested at NEETRAC, the HVW outperformed all other arcing
horns in head to head competition. The HVW is now available for all SEECO
group operated switches, including side-break and center Vee style
switches. Retro-fit kits for other brands and switch styles will be
available in mid 2009. Contact the factory for additional details. |
|
|
| |
|
 |
Our most recent major new product introduction is a
remote
I/O device that allows for RF and optical fiber communication between
devices. This can be used in both substation and transmission
applications and provides a convenient means for communication of status and relay control without the time and expense of traditional
trenching and multi wire cabling. |
| |
|
 |
The Current and Voltage Detection Board (CVD) provides local detection of
fault events in conjunction with motor operated pole-top switches,
enabling local automatic or remotely controlled sectionalizing and fault
isolation. In automatic mode, the CVD board will initiate motor
operation of the associated switch (open or close) after recognition of a
valid fault event. In remote mode, the fault event triggers a
contact closure through an RTU and operation of the switch is initiated
remotely at the discretion of utility personnel. The CVD board
utilizes current and voltage inputs provides by separate
current and voltage
sensors, instrument transformers or similar devices. |
| |
|
 |
The Auto Sectionalizing Board (ASB) provides simple, user configurable
control logic for the independent and automatic operation of motor
operated pole top switches. The ASB will initiate motor operation of
the associated switch (open or close) based on the presence or absence of
voltage, with or without time delay. Voltage indication is provided
by a separate voltage sensor, potential
transformer or similar device. |
|
|
|
 |
Here we grow again!
Construction was completed in late 2003 and our new manufacturing facility
(plant 2) entered service in early 2004.
This new facility adds approximately 12,000 additional square feet of
assembly space to support continued growth in motor operator, interrupter
and sensor sales and production. In addition, this facility will
provide much needed room for our growing product development and testing
activities. |
|
